Articles
Spot weld removal with the Powermax45 XP plasma system
Posted on 07/12/2022
Tips and techniques on using the Powermax45® XP plasma system for spot weld removal. Read more
Metal marking with the Powermax45 XP plasma system
Posted on 06/28/2022
Tips and techniques on using the Powermax45® XP plasma system for metal marking applications. Read more
Plasma cutter gouging techniques
Posted on 05/03/2016
Plasma cutter operators use a variety of techniques to achieve different gouge profiles and sizes, whether gouging by hand or using a mechanized method like a track cutter. Read more
Improve plasma cut quality with these CNC steel and metal cutting tips
Posted on 04/07/2016
There are a lot of factors that go into producing a quality plasma cut. This plasma cutting tips reference guide offers several solutions to help improve cut quality. It is important to try and work through all of the relevant suggestions provided – as often there are many different factors to consider. Read more
Laser O2 cutting guide for mild steel
Posted on 04/07/2016
Tips for mild steel cutting with O2. Read more
Plasma cutting machine maintenance
Posted on 02/02/2016
Murphy's Law says the plasma cutting machine will break down when you need it most—usually right in the middle of a big plate-cutting job. At up to $200 per hour fully burdened cutting-machine downtime gets expensive. Here is a checklist that serves as a good starting point for a preventive maintenance program. Read more
Troubleshooting plasma cutter cooling systems
Posted on 02/02/2016
Increase uptime and parts life by keeping your plasma cutting system cool. Get troubleshooting tips. Read more
Automated plasma cutting tips and techniques
Posted on 02/02/2016
Proper piercing technique leads to lower operation costs and improves productivity. Read more
Plasma cutter - starting problems
Posted on 02/02/2016
The torch fails to initiate the cutting arc when all other conditions for normal operation are correct—power supply energized, safety and parts-in-place interlocks satisfied, gas pre-flow at torch, and torch within transfer distance. Read more
Gas selection guide for plasma cutting aluminum, stainless steel, and mild steel
Posted on 02/02/2016
This article provides a brief overview of the advantages and disadvantages of each gas and makes "best case" recommendations for cutting the three most common materials: mild steel, stainless steel and aluminum. Read more
Resource center |
Support by product |
System support |
Software support |
Documents library |
Videos |
Training |
Articles |
SPARK the blog |
FAQs |
For educators |
Tradeshows and events |
Hypertherm Cutting Institute
Visit the Hypertherm Cutting Institute, an online classroom that offers valuable information about Hypertherm’s products and cutting in general.