Articles
Plasma cutting machine maintenance
Posted on 02/02/2016
Murphy's Law says the plasma cutting machine will break down when you need it most—usually right in the middle of a big plate-cutting job. At up to $200 per hour fully burdened cutting-machine downtime gets expensive. Here is a checklist that serves as a good starting point for a preventive maintenance program. Read more
Troubleshooting plasma cutter cooling systems
Posted on 02/02/2016
Increase uptime and parts life by keeping your plasma cutting system cool. Get troubleshooting tips. Read more
Automated plasma cutting tips and techniques
Posted on 02/02/2016
Proper piercing technique leads to lower operation costs and improves productivity. Read more
Plasma cutter - starting problems
Posted on 02/02/2016
The torch fails to initiate the cutting arc when all other conditions for normal operation are correct—power supply energized, safety and parts-in-place interlocks satisfied, gas pre-flow at torch, and torch within transfer distance. Read more
Gas selection guide for plasma cutting aluminum, stainless steel, and mild steel
Posted on 02/02/2016
This article provides a brief overview of the advantages and disadvantages of each gas and makes "best case" recommendations for cutting the three most common materials: mild steel, stainless steel and aluminum. Read more
Like us
Follow us
Watch us
Connect with us
Follow us
Follow us
Hypertherm Cutting Institute
Visit the Hypertherm Cutting Institute, an online classroom that offers valuable information about Hypertherm’s products and cutting in general.