• Products & Services
  • Mechanized Plasma
  • Manual Plasma
  • Torch & Consumables
  • Product Upgrades
  • Automation
  • Centricut
  • Laser
  • Nesting & process optimization software
  • Service
  • Training
  • Product Registration
  
  
  • Warranty
  • Where to Buy
  • EU Regulations
• Applications
  • Manual Plasma Applications
  • Mechanized Plasma Applications
• Information Center
  • Plasma Education
  • Plasma or Oxyfuel?
  • What is Plasma?
  • Right Time to Invest?
  • Published Articles
  • Videos
• Company
  • About Us
  • Careers
  • Community Relations
  • Company Store
  • Contact Us
  • News Room
  • Press Releases
  • Trade Shows
  • Visit Us
  • Voice of the Customer

Phoenix Software Controller Downloads - Demo versions and Control versions

Phoenix Software Controller Updates

Phoenix® Software is the Hypertherm branded CNC control software. The design of the software is centered on combining advanced cutting capability with an easy to use graphical user interface that allows the end user a full range of application flexibility. The release of Version 8 focuses on functionality for both easier table operation and serviceability. Using the new CutPro™ Wizard, it is now possible to reduce the time for a new operator to be able to cut a good part from a prepared file to less than 5 minutes.

Below is the latest version of software for each class of controllers. Updates within each main version number (for example V7, or V6, etc.) are provided free of charge. In some cases these updates will include new features, or they may simply have bug fixes. If you are in doubt about downloading and installing a software update please contact Technical Support at Hypertherm and we will be glad to discuss your requirements.

If your requirements (and the hardware capabilities of your control) dictate that a change between main version numbers is required then there will be a nominal charge for the update. Please contact Technical or Customer Support at Hypertherm for further information on the hardware requirements and possible costs involved with a change.

Each version section below includes files needed to completely update a controller: VERY IMPORTANT : When updating your CNC to the latest version using the download files, it is critical to install the new files in the following sequence: 1. Update the software files first 2. Update the help file 3. Update the cut charts This will prevent installation of cut charts with a software version that does not support them. If you are an MTC Software customer using ProNest and use an HPR plasma system for marking, the Phoenix version 8.5 software requires a small update to your ProNest settings. Contact MTC technical support at 716-434-3755 ext. 3.  For other brands of post-processor software, contact your supplier for further information.

The files below include: Release bulletin Update disk images - either as disks or upload to a memory stick (thumb drive) Help file images Drivers for the HASP device installed on your system Cut chart data which you download as a single zip file and expand onto a memory stick. Place the memory stick into a USB port and select "load cut chart" from the cut charts screen on the controller.

Current Controller Software Files (Phoenix Software)

If you are updating your Phoenix software from a minor release of one version (for example, 7.50.3) to any version of a later, major release (for example, 8.50.0), you must first update to the latest minor release of your current version (for example, 7.50.5) before you update to the later, major release.

Software is available in various languages.
Install the ENGLISH version below, then click here to go to the translated software.

• Site Map
• |
• Careers
• |
• Privacy Policy
• www.hypertherm.com